basket
Store Locations (Mon - Sat: 8:00 am - 5:00 pm)
Outside Arizona: 800-423-2450    |   Phoenix: 602-504-1931    |   Tempe: 480-355-5090   |   Tucson: 520-745-8301
email newsletter


How to Flush Trim Solid Wood Edge Banding on Plywood or Melamine with a Router Table

by Mark Stephens | September 6th, 2013

Covering the edges of plywood or melamine on your woodworking project can be done several ways. One of the most favorable is to use solid wood edging, and there are multiple ways to do this too. A straightforward method is to glue 3/4″ x 1-1/2″ strips to the plywood edge and leave it proud of the top by a hair. Then use a flush trim bit in a router to get it perfectly flush with the plywood. Doing this with a hand held router is a dubious exercise – the router is just too unstable riding on a 1-1/2″ wide strip. So do it in your router table with a tall fence. It’s safer, easier, and faster. Steve Emmons demonstrates it in this good and short video.

The traditional way to trim solid wood edge banding flush is to use your hand plane and/or a cabinet scraper. And that’s a fine method too. When you have several shelves or cabinet sides to trim flush, you’ll knock it out faster on your router table, though.

Tags: , ,

This entry was posted on Friday, September 6th, 2013 at 1:29 pm and is filed under Tips and Tricks. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.